Abocom RE450 Installationsanleitung PDF herunterladen (Seite 7)

Preparing an Imaging Server 443

Novell Confidential Manual (99a) 28 October 2003

40 Preparing an Imaging Server

The following are the requirements for the imaging server:

If you want to store an image locally (on a CD, hard disk or Jaz* drive) rather than on an imaging

server, see “Using a CD” on page 465 and “Using a Hard Disk or Jaz Drive” on page 466 in

Chapter 44, “Setting Up Disconnected Imaging Operations,” on page 465.

Requirement Explanation

A fixed IP address When you connect to the imaging server during a workstation imaging operation, you must do so using

the fixed IP address or DNS name of the imaging server.

Enough space to

store a workstation

image

Unless you use compression (which is enabled by default) for your workstation images, they are nearly

the same size as the data on the workstation hard disk, which could be hundreds of MB.

The Imaging and

Automatic

Workstation Import

components of ZfD

installed

These software components enable the server to act as an imaging server and to register workstations

in NDS

or Novell

eDirectory

for auto-imaging (unattended) operations. If you have already done a

typical ZfD installation on the server, the server is ready to act as an imaging server. If not, use the

following steps to install the needed components:

1. Make sure your server meets the requirements specified in Preparing for the ZfD Server Installation

in the ZENworks for Desktops 4.0.1 Installation Guide guide.

2. Run the ZfD installation program (winsetup.exe) either on your server (Windows NT/2000/XP) or from

a Windows workstation with a drive mapped to your server (NetWare

3. When prompted for the NDS or eDirectory tree to install to, choose the tree that your server is in.

4. When prompted for the components to install, choose Automatic Workstation Import and Imaging.

5. When prompted for the import/removal role, choose Import.

6. If you are installing Preboot Services (PXE), select this component when prompted.

7. When the installation is done, restart your server.

1 2 3 4 5 6 7 8 9 10 11 12 ... 77 78

Keine Kommentare

Abocom RE450 Installationsanleitung Seite 7