Abocom Modem UTM560 Bedienungsanleitung

USB V.90 TINY MODEM Quick Installation Guide

- 6 - Setup Diagnostics You can perform the following steps to check if your USB V.90 Tiny Modem is well installed. 1. Go to Start→Settings→Control

Installation for Windows 2000 1. Once the USB V.90 Tiny Modem is well connected to your computer, Windows 2000 will automatically detect the new dev

- 8 - 4. Click Browse button and select the drive where you load the device driver (for example: G:\WIN2K). Click OK. Windows will start searching

- 9 - Setup Diagnostics To verify whether your USB V.90 Tiny Modem exists in your computer and is enabled, go to My Computer→Control Panel→System.

Installation for Windows Millennium 1. When the USB V.90 Tiny Modem is well connected to your computer, Windows ME will automatically detect the new

- 11 - 3. Expect a minor delay for Windows to search for the appropriate driver for the device. Click Next. 4. Click Finish. The installation progr

- 12 - 7. Click Next. 8. When Windows prompt you “Modem Country Selection”, choose the country where you locate. Select the Enable PBX check box

Setup Diagnostics 1. To verify if the USB V.90 Tiny Modem is well installed and enabled, you can perform the following steps. 2. Go to StartSetti

Internet Access 1. Go to My Computer. 2. Select Dial-Up Networking. 3. Double-click Make a New Connection, a dialogue box will appear for you to na

- 15 - 7. Now, you are ready to connect to the Internet.

FCC REGULATORY STATEMENTS The United States Federal Communication Commission (FCC) and the Canadian Department of Communications have established c

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

Table of Contents Introduction ...1 SPECIFICATIONS...

Introduction The USB V.90 Tiny Modem complies with the Universal Serial Bus functionality built in Windows 98/2000/Millennium. It is compatible with

- 2 - System Requirements  A Pentium processor-based personal computer 166MMX or above  At least 16 MB of RAM  An USB port  Microsoft Wind

Hardware Installation 1. Locate the USB host port of your system. Connects the USB Type A connector to the USB host port on your computer. 2. Conn

Software Installation Installation for Windows 98 1. When the USB V.90 Tiny Modem is well connected to your computer, Windows 98 will automatically

- 5 - you load the device driver. Click Next. Windows will start searching for the appropriate driver for the software installation. 4. Click Next.